I VCDS'ed again to see what the codes where they fallow:ġ8014 - Rough Road/Engine Torque Signal from ABS I then shut the car off and removed the battery so I could atleast get it home. I had to feather the clutch to get pulled off to the side of the road. I was driving today with my high idle that is plagueing me, while cruising the EPC light came on and the car started bucking and wouldnt accelerate, limp mode I guess. Monitor Labels: 4B0-951-173.lblĪddress 55: Xenon Range Labels: 4B0-907-357-AUT.lblĠ1537 - Vehicle Level Sensor Supply VoltageĠ0774 - Level Control System Sensor Rear Left (G76)Īddress 56: Radio Labels: 8D0-035-1xx-56.lblĦ5535 - Internal Control Module Memory ErrorĮnd. Locks Labels: 8D0-862-257.lblĠ1367 - Central Locking Pump Run Time Exceeded (Likely Leak)Ġ1371 - Alarm triggered by Door Contact Switch Driver's SideĠ1372 - Alarm triggered by Door Contact Switch Rear Passenger SideĠ1370 - Alarm triggered by Interior MonitoringĪddress 45: Inter.
#VCDS 12.12 EBAY PLUS#
P1568 - 35-10 - Mechanical Failure - IntermittentĪddress 03: ABS Brakes Labels: 8E0-614-111-EDS.lblĠ0787 - Temperature Sensor in Fresh Air intake duct (G89)ģ0-10 - Open or Short to Plus - IntermittentĠ1272 - Positioning Motor for Central Flap (V70)Ĥ1-10 - Blocked or No Voltage - IntermittentĠ1271 - Positioning Motor for Temperature Flap (V68)Ġ0600 - Potentiometer On Positioning Motor for Temperature Flap (G92)Īddress 15: Airbags Labels: 8D0-959-655-AI8.lblĪddress 17: Instruments Labels: 8D0-920-xxx-17.lblĪddress 35: Centr. I dont want to start throwing parts at it till I have a better idea of what is going on.Ĭhassis Type: 8D - Audi A4/S4/RS4 B5 (1995 > 2001)
#VCDS 12.12 EBAY FULL#
I have a full auto scan: hope someone can see something in there that might throw up a red flag.
![vcds 12.12 ebay vcds 12.12 ebay](https://www.vp44.fr/wp-content/uploads/2013/07/scanner-vag-com-1210-300x300.jpg)
![vcds 12.12 ebay vcds 12.12 ebay](https://www.marocbikhir.com/oc-content/uploads/3482_thumbnail.jpg)
By the way the car runs and drives it just idles at 1200 RPM. I have read everything from a bad ECU to a bad throttle body. I just cleaned my throttle body and attempted to allign it but I just keep getting error, even after clearing codes out of VCDS.